Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Ducati Scrambler
Part:

Discover the main instructions to remove and replace the timing belt on the Ducati Scrambler. First, place your bike on a stand and start by removing the side plastic cover of the timing belt, unscrewing all the fixing screws; then take the necessary references by locating the marks on the engine casing, and remove the timing belt. At this point, install the new belt, tightening to the torque specified in the user and maintenance manual, following the video to the end!

Updated on 24 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Front Brake Pads on the Ducati Scrambler
Replacing the Front Brake Pads on the Ducati Scrambler
Scrambler In today's video, we will see the instructions on how to remove and replace the front brake pads, as well as the rear ones, on the Ducati Scrambler. …
How to Replace the Handlebars on the Ducati Scrambler
How to Replace the Handlebars on the Ducati Scrambler
Scrambler This guide provides instructions on how to remove and replace the handlebars on the Ducati Scrambler motorcycle, following the steps outlined below. …
Replace the Clutch on a Ducati Scrambler
Replace the Clutch on a Ducati Scrambler
Scrambler In today's tutorial video, we will see the main steps to disassemble and replace the clutch kit on the Ducati Scrambler by following these simple ste…

Servicing a Honda SH300 Scooter

How to service the SH 300 scooter. This operation should be done with the engine cold. Remove the cover and take out the air filter, cleaning the compartment where the new one will be placed. Refit the three screws you removed earlier and reassemble the cover. Remove the oil cap, take a 12 mm spanner and unscrew the oil plug from underneath. Allow the oil to drain into a suitable container, which you will then dispose of at an authorised centre. Remove the filter, clean the cavity where the new one will be fitted, and tighten it with the spanner. Refit the oil cap screw. Always change the washer on the cap. Now, refill with oil. You will need a synthetic oil like Motul 5100 10W40, which costs £12.40 per litre on Amazon. If you are doing a complete change, you will need two cans, as you will require 1.6 litres including the filter. After adding the oil, let it rest for a few minutes, then run the engine for a few minutes and check the level. If necessary, top it up: it should be halfway between min and max.

Watch the video!


by ScegliAuto

More videos