Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Spark Plugs on a Ducati Scrambler 800

Model: Ducati Scrambler 800
Part: Spark plugs

Video tutorial

Follow these step-by-step instructions to remove and replace the spark plugs on the Ducati Scrambler 800 engine. First, place the motorcycle on the centre stand and disconnect the spark plug cap or connector.

Then, use a socket spanner with an extension to unscrew and remove the spark plug from the cylinder head, as shown in the video. Now, install the new spark plug of the correct type and with the same thread pitch; screw it in by hand and then tighten gently with the spanner, following the video tutorial to the end!


Updated on 8 September 2026 by ScegliAuto


Related tutorials

How to Replace the Battery on a Ducati Scrambler 800
How to Replace the Battery on a Ducati Scrambler 800
Scrambler 800 The instructions in this guide illustrate the steps to remove and replace the battery on the Ducati Scrambler 800 motorcycle. First, place the motorc…
How to replace the rear suspension on the Ducati Scrambler 800
How to replace the rear suspension on the Ducati Scrambler 800
Scrambler 800 In this video tutorial, you will see step-by-step instructions to remove and replace the rear suspension on the Ducati Scrambler 800. First, position…
How to Change the Engine Oil in a Ducati Scrambler 800?
How to Change the Engine Oil in a Ducati Scrambler 800?
Scrambler 800 In this tutorial, you will see how to change the engine oil in a Ducati Scrambler 800, which is an extremely simple and quick task. First, wait until…

The First Service at 1,000 Miles on the Honda SH 125

Let's see what needs to be done at the first service for the Honda SH 125 at 1,000 miles. First, change the oil (0.8 litres of original Honda 10W30 oil), clean the metal mesh filter, and reset the service light. Place the scooter on its side stand to allow the oil to drain better, unscrew the drain bolt on the left side, clean the metal mesh filter, replace the sealing ring, unscrew the central bolt, wait for everything to drain, then refit the screws (tightening torque on the side 20 Nm, central 24 Nm); pour in the Honda oil, start the engine for 30 seconds (bike upright, not on the stand). Turn off and wait 2 minutes. Check the level and reset the light by pressing the SET+ button and ignition at the same time.

Watch the video!


by ScegliAuto

More videos