Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
The replacement of the exhaust of the Royal Enfield Interceptor 650 can be done by loosening the screws on the appropriate supports located on the left side of the motorcycle, near the rear wheel: once the connecting clamp that joins the exhaust to the manifold has been removed, it will be possible to completely detach the terminal from its seat so that the new one can be inserted in its place. Once the installation is complete, the new replacement part can be secured with the corresponding screws, in order to verify that everything is functioning properly.

Posted on 23 November 2025 by ScegliAuto

Video tutorial

Related tutorials

How do you replace the exhaust pipe of the Royal Enfield Interceptor 650?
How do you replace the exhaust pipe of the Royal Enfield Interceptor 650?
Interceptor 650 The replacement of the Royal Enfield Interceptor 650 exhaust can be performed by unscrewing the screws that secure the exhaust to the specific suppor…
How do you replace the muffler of the Royal Enfield Interceptor 650?
How do you replace the muffler of the Royal Enfield Interceptor 650?
Interceptor 650 In order to replace the exhaust pipe of the Royal Enfield Interceptor 650, you need to loosen the screws that secure the exhaust pipe to the appropri…
How do you replace the muffler of the Royal Enfield Interceptor 650?
How do you replace the muffler of the Royal Enfield Interceptor 650?
Interceptor 650 It will be possible to replace the exhaust pipe installed on the Royal Enfield Interceptor 650 by loosening the screws that secure the terminal to it…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos