Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In this video, you will learn how to perform the routine maintenance service on a Royal Enfield Bullet 350 and 500, following the instructions below. First, position the motorcycle on the centre stand and remove the oil drain bolt located under the engine using a socket; then allow the oil to drain into a container for about ten minutes. Next, proceed with replacing the oil filter by unscrewing the cover screws; finally, pour the new engine oil of the correct type into the fill hole!

Updated on 16 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Battery on a Royal Enfield Bullet 350 - 500
How to Replace the Battery on a Royal Enfield Bullet 350 - 500
Bullet 500 In today's video, you will learn how to remove and replace the battery on the Royal Enfield Bullet 500, as well as the 350, by following these simple…
Engine Oil and Oil Filter Replacement on a Royal Enfield Bullet 500
Engine Oil and Oil Filter Replacement on a Royal Enfield Bullet 500
Bullet 500 Regular maintenance servicing must be carried out, following the instructions in the owner's manual; let's see how to do it on a Royal Enfield Bullet…
How to Replace the Main Fuse on a Royal Enfield Bullet 500
How to Replace the Main Fuse on a Royal Enfield Bullet 500
Bullet 500 This guide outlines the procedure to remove and replace the main fuse of the electrical system on a Royal Enfield Bullet 500 motorcycle. First, place…

How to Remove and Install the Rear Wheel on a BMW GS 1250R

In this video, you will see how to remove and reinstall the rear wheel on a GS 1250R: the first step is to place the bike on a support stand and remove the five nuts that hold the rear wheel in place (it is better if the bike is in first gear). Keep in mind that when remounting the tyre, it has a direction of rotation indicated by an arrow that must face forward. Now, place the wheel onto the hub and then insert the bolts, which you will initially tighten by hand and then with a torque wrench to 60 Nm. Mark the bolts to visually check if any are loosening.

Watch the video!


by ScegliAuto

More videos