Do it yourself
Frequently asked questions about cars and motorcycles

Why Does the Fiat 500 Speedometer Flash After Installing a New Radio?

Model: Fiat 500 312 - Years: 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018
Part: Dashboard

See other generations:
Video tutorial

The issue of the Fiat 500 speedometer flashing after fitting a new radio is common and well-known. It is not a mechanical fault, but an electronic/communication reason; indeed, the Fiat 500 uses the CAN bus network, and all the control units communicate with each other over this network.

The original radio is an active node, and when you install an aftermarket radio, this communication is interrupted. Thus, the instrument cluster interprets this absence as a fault or loss of communication across the entire CAN bus network, signalling it by flashing the speedometer to draw attention; however, the vehicle operates perfectly.

The best solution is to use a suitable CAN bus interface, an adapter that connects between the new radio and the vehicle's original wiring. You can find this device on Amazon with the code B0FG1WPRRY for £37.77 with free delivery.

The installation is plug & play and completely resolves the issue.


Posted on 18 August 2026 by ScegliAuto


Related tutorials

Fiat 500 (2007-2024 / 312) The issue of the mileage flashing after installing an aftermarket radio is common in Fiat 500s: this is because the original Fiat radio communicates …
Fiat 500 (2007-2021 / 312) Here’s how to remove the radio from the dashboard of a Fiat 500. Remove the buttons on opposite sides of the radio to insert the removal keys as show…
Fiat 500 (2007-2024 / 312) Removing the radio from a Fiat 500? Follow these steps for removal and installation on the 500. Use original or aftermarket metal keys to detach the …

    Frequently Asked Questions

    • 500 2007-2024 - How much does it cost to replace the dashboard dashboard of the FIAT 500? Read answer

How to Activate or Deactivate 4x4 Traction on a Toyota RAV4

Below are the steps to activate or deactivate the 4x4 traction on a Toyota RAV4, following the instructions provided. First, get in the vehicle and start the engine; then press the 4x4 traction button located on the left side of the steering wheel to deactivate it. With the 4x4 traction deactivated, the warning light will illuminate on the instrument panel; simply press the button again to activate the vehicle's four-wheel drive, allowing you to tackle off-road or rough terrain.

Watch the video!


by ScegliAuto

More videos