Do it yourself
| ||||
|
Fiat Punto - Video tutorial
Model: Fiat Punto
188, MK 2
- Years 1999-2011 To be able to disassemble the window motor it is first necessary to remove the door panel: this operation is extremely simple as there are only a few fixing screws and press-studs along the edges. Once the panel has been removed, lower the glass so as to be able to access the retainer for fixing the glass to the lifting mechanism; then remove the plastic split pin and unhook the glass from the sliding shoe, take it to the side and secure it with paper tape to the door pillar; at this point you can disconnect the power plug from the motor. Then unscrew the fixing pins of the window lifting mechanism and remove it complete with motor. Proceed backwards to install the new mechanism, paying attention to fastening the glass to the sliding shoe.
Posted on 28 July 2023 by ScegliAuto
Replacement rear window lifter on Grande Punto
Fiat Punto (2005-2018 / Punto EVO, Grandepunto , MK 3, 199) Replacing the window regulator on a Fiat Grande Punto? We remove the panel to access the window motor. We remove the crank of the manual window lift
How to disassemble the door panel and power window motor?
Fiat Punto (2005-2018 / Punto EVO, Grandepunto , MK 3, 199) To disassemble the manual window regulator of the 2010 Fiat Grande Punto, you will first need to remove the door panel. The process is very simple an
How do you replace the window regulator of the Fiat Grande Punto?
Fiat Punto (2005-2018 / Punto EVO, Grandepunto , MK 3, 199) In order to replace the window regulator of the Fiat Grande Punto, you need to loosen the screws that secure the door panel corresponding to its hous Other guides that may interest you
|
Frequently Asked QuestionsHow do I replace the Land Rover Evoque auxiliary battery?In order to replace the auxiliary battery of the Land Rover Evoque, it is necessary to go inside the passenger compartment and remove the panel which is positioned immediately under the glovebox. Once the screws that secure this panel have been loosened, it will be possible to access the components located in its rear part, including the auxiliary battery. The latter must be disconnected from its cables and the fixing screws must be loosened. The battery can then be replaced with a new one and the panel can be fixed again with its screws. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.046
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |