Do it yourself
Frequently asked questions about cars and motorcycles

How to Adjust the Carburettor Solenoid on a Gilera DNA 50?

Model: Gilera Dna 50
Part: Carburetor

Video tutorial

To adjust the carburettor solenoid on the Gilera DNA 50, first remove the solenoid from its housing. This can be accessed from underneath the bike, just below the rear mudguard and near the rear swingarm.

The solenoid can be removed by loosening the screws that secure it and disconnecting the connector. This will allow you to adjust its intensity following the instructions shown in the video.

After adjustment, reinstall the solenoid, ensuring everything functions correctly.


Updated on 30 September 2026 by ScegliAuto


Related tutorials

Dna 50 In today's video, we will go through the steps to remove and replace the fuel pipe on a Gilera Dna 50cc. First, remove the side panels of the scooter…
Dna 50 Hello, today you will learn how to replace the spark plug on your Gilera DNA 50. Start by carefully removing the side fairings of the bike. Next, dis…
Dna 50 To replace the variator on a Gilera DNA 50, open the transmission cover located near the rear wheel on the left side of the bike. Once the cover has …

How to Replace the Rear Brake Pads on the Kymco AK 550

You can replace the rear brake pads on the Kymco AK 550 by loosening the screws that secure the brake caliper in its housing: once these screws are loosened, you can detach the caliper from the disc so that the pads inside can be extracted. The pin that holds them in place must also be removed to allow the new pads to be installed: secure the new pads in the caliper, then reinstall the caliper onto the disc, ensuring everything functions correctly.

Watch the video!


by ScegliAuto

More videos