Do it yourself
Frequently asked questions about cars and motorcycles
In order to disassemble the engine of the Harley Davidson Shovelhead, you need to loosen the screws that secure the engine block to its seat, so that it can also be freed from the connectors and all the intake and exhaust pipes: in this way you can extract the engine block, proceeding by loosening the screws that secure the cylinders. By removing these from their seat, you can free the pistons from the connecting rods, so that they can be removed and also free the crankshaft; all further components can be replaced with new spare parts, reassembling the engine.

Posted on 12 April 2025 by ScegliAuto

Video tutorial

Related tutorials

Shovelhead In order to replace the clutch of the Harley Davidson Shovelhead, you need to loosen the screws that secure the cover casing on the right side of the…
Shovelhead To change the oil of a Harley Davidson Shovelhead, start by warming up the engine for a few minutes to make the oil more fluid and facilitate drainag…

How to Service the Beta RR 350

This video will illustrate the steps to perform the routine maintenance service, replacing the engine oil and oil filter on the Beta RR 350 enduro bike. First, place the bike on a stand and start by loosening the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then clean the small oil filter (replacing it with a new one if too dirty). Finally, top up with new oil, of the correct type for your engine, filling to the maximum level!

Watch the video!


by ScegliAuto

More videos