Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In this guide, you will learn how to remove and replace the battery on a Harley Davidson Street Bob in simple and quick steps. First, remove the seat by unscrewing the rear screw; then remove the side cover of the battery located on the right by unscrewing the lower screw, as shown in the video. At this point, disconnect both battery terminals (positive and negative) and remove the central strap; replace the old battery with a new one of the same amperage.

Updated on 31 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Mirrors on a Harley Davidson Street Bob
How to Replace the Mirrors on a Harley Davidson Street Bob
Street Bob To replace the mirrors on a Harley Davidson Street Bob, you need to loosen the nuts that secure the mirrors to their housing: these nuts will be loca…
How do you replace the air filter of the Harley Davidson Street Bob?
How do you replace the air filter of the Harley Davidson Street Bob?
Street Bob To replace the air filter of the Harley Davidson Street Bob, you will need to loosen the screws that secure the filter cover housing: it will be loca…
Battery replacement for Harley Davidson Street Bob
Battery replacement for Harley Davidson Street Bob
Street Bob Today's main instructions will show us how to disassemble and replace the battery of the Harley Davidson Street Bob motorcycle. First, we put the mot…

How to Turn Off the "V-Belt" Warning Light on a Yamaha X-MAX 400 Scooter?

In this tutorial, learn how to turn off the "V-Belt" warning light on the Yamaha X-MAX scooter's instrument panel, a very simple and quick operation. Before doing this, ensure you have completed the required maintenance, specifically replacing the drive belt. Start by inserting the key and turning on the ignition, then open the small right glove compartment and unscrew the screw for the upper cover. Once removed, locate the white connector with a jumper attached, disconnect it, wait about 10 seconds, and reconnect it. If successful, the warning light will disappear.

Watch the video!


by ScegliAuto

More videos