Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
To replace the stator on the Honda CBR 929, loosen the bolts securing the seat to its housing to gain access to the components underneath: disconnect the motorcycle battery before removing the stator. The stator is accessible from the right side of the bike: unscrew the bolts securing the side panel under the tank and those securing the additional cover underneath. You can now remove the stator by disconnecting the power cables; this will allow you to fit a new replacement part, reassembling all previously removed components.

Updated on 26 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Grips on the Honda CBR 929 RR
How to Replace the Grips on the Honda CBR 929 RR
Cbr 929 Watch this video to learn how to remove and replace the grips on the Honda CBR 929 RR Fireblade motorcycle, following the instructions below. First, …
Replacing the Front Headlight Bulb on a Honda CBR 929 RR Fireblade
Replacing the Front Headlight Bulb on a Honda CBR 929 RR Fireblade
Cbr 929 In this video, you will see the steps to remove and replace the front headlight bulb on a Honda CBR 929 RR Fireblade. To access the bulb, it is not n…
Replacing the Clutch on a Honda CBR 929
Replacing the Clutch on a Honda CBR 929
Cbr 929 In this video tutorial, you will see all the steps to remove and replace the clutch assembly on a Honda CBR 929. First, immerse the new clutch discs …

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos