Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Change the Engine Oil of a Honda CB 750?

Model: Honda Cb 750
Part: Engine oil

Video tutorial

To change the engine oil of a Honda CB 750, start by warming up the engine for a few minutes to make the oil more fluid and facilitate drainage. Turn off the engine and ensure the bike is securely positioned on a centre stand.

Under the engine, locate the oil drain plug. Position a collection tray under the plug and use a spanner to carefully unscrew it, allowing all the used oil to drain out. Once fully drained, re-screw the drain plug and tighten it securely.

Next, locate the oil filler cap, which is found on one side of the engine. Remove this cap and use a funnel to slowly pour in the recommended amount of new engine oil as stated in the owner's manual.

After adding the oil, replace the filler cap and ensure it is tightly secured. Start the engine and let it run for a few minutes, then turn it off and check for any oil leaks.

This process ensures that your Honda CB 750 runs with fresh, clean oil.


Updated on 9 October 2026 by ScegliAuto


Related tutorials

How to Change the Engine Oil and Oil Filter on a Honda CB 750
How to Change the Engine Oil and Oil Filter on a Honda CB 750
Cb 750 Let's go through the procedure for performing the routine maintenance service by changing the engine oil and oil filter on the Honda CB 750. First, p…
How to Replace the Engine Oil and Oil Filter of the Honda CB 750
How to Replace the Engine Oil and Oil Filter of the Honda CB 750
Cb 750 The process of replacing the engine oil and oil filter takes only a few minutes; let's see how to perform the routine maintenance service on the Hond…
Front Brake Lever Replacement for Honda CB 750
Front Brake Lever Replacement for Honda CB 750
Cb 750 Today, you will see how to remove and replace the front brake lever of a Honda CB 750 in simple steps. First, unscrew the bolt located under the fron…

How to replace the drive belt on the Yamaha Xmax 300

Here are the instructions for removing and replacing the drive belt on the Yamaha Xmax 300 scooter. First, place the scooter on its centre stand and start unscrewing all the screws securing the transmission cover, which are located on the sides; then unscrew the central nut of the fan and subsequently that of the clutch bell, as shown in the video. Once the components are removed, take out and replace the drive belt with a new one; reassemble or replace the entire clutch pack if necessary.

Watch the video!


by ScegliAuto

More videos