Do it yourself
Frequently asked questions about cars and motorcycles
It will be possible to replace the motor oil of the Husaberg TE 250 by loosening the drain plug of the oil pan, which will be located in the central lower part of the vehicle: once the plug has been removed, it will be possible to proceed by collecting the used oil in a container. It will then be possible to remove the oil filter located in the same position in order to insert the new replacement part; after the replacement, a top-up can be performed. The necessary amount of oil must be inserted through the vent on the right side of the motorcycle.

Posted on 6 June 2025 by ScegliAuto

Video tutorial

Related tutorials

Te 250 In order to disassemble the engine of the Husaberg TE 250, you need to loosen the screws that hold the motorcycle's cylinder in place at the top. Onc…
Te 250 In order to replace the fuel tank of the Husaberg TE 250, you need to loosen the screws that secure the side panels of the fairing, so that they can …
Te 250 You can change the engine oil on the Husqvarna TE 250 by loosening the drain plug located at the central lower part of the vehicle: once this plug is…

How to Remove the Rear Wheel on the BMW G650 GS?

In this tutorial, you will see how to remove the rear wheel on the BMW G650 GS, a very simple operation. First, lift the motorcycle from the central area using a stand or a jack, then undo the right nut with a 24 mm socket and the left one with a 19 mm spanner. Once done, using a Torx T40 key, unscrew the two chain tensioner bolts exactly half a turn each, until you loosen the tension. Finally, push the wheel towards the inside of the motorcycle, remove the chain from the sprocket, and extract the inner pin using a hammer.

Watch the video!


by ScegliAuto

More videos