Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Steering Bearings on a Husqvarna CR 125?

Model: Husqvarna Cr 125
Part: Bearing

Video tutorial

To replace the steering bearings on a Husqvarna CR 125, loosen the bolts securing the top clamp and then completely remove the handlebars. At this point, give a few taps with a hammer to extract the pin along with the entire front end. By separating the lower clamp from the fork, you can remove the bearing.

Before inserting the new one, lubricate the fork and the sliding plates. Once this operation is complete, remount the fork, handlebars, and all previously removed parts.


Updated on 20 April 2026 by ScegliAuto


Related tutorials

How to Replace the Piston of the Husqvarna CR 125
How to Replace the Piston of the Husqvarna CR 125
Cr 125 To replace the piston of the Husqvarna CR 125, loosen the retaining ring of the side pipe, then disconnect the pipe. Once the pipe is removed, open t…
How to Change the Transmission Oil on a Honda CR 125
How to Change the Transmission Oil on a Honda CR 125
Cr 125 Follow these main steps to perform routine maintenance by changing the transmission and clutch oil on a Honda CR 125 two-stroke enduro bike. First, p…

How to replace the battery on a BMW G310 GS?

On the BMW G310 GS, you can replace the battery by inserting the key into the designated lock and turning it to remove the seat. Once the seat is removed, you can loosen all the screws securing the battery and disconnect the terminals; the battery is located under the seat. When all screws are loosened and terminals disconnected, the battery can be pulled out of its housing and replaced with a new part. The new battery should then be connected and secured, and finally, the seat can be reinstalled.

Watch the video!


by ScegliAuto

More videos