Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Check the engine oil through the small window located on the right fairing of the bike, at the bottom. Ensure that your fluid level is between the two marks. If it is below the lower mark, top it up through the upper fill hole of the oil tank. It is recommended to use Motul 7100. Next, check the brake fluid, which should be changed approximately once a year, or less frequently, or when you decide to perform a complete brake bleed. Finally, check the thickness of the brake pads: if they are nearly worn out, replace them to avoid damaging the brake discs. These are some of the checks to perform periodically to enhance the life and durability of your bike.

Updated on 18 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to remove and replace the front wheel of the Kawasaki ZX-10R
How to remove and replace the front wheel of the Kawasaki ZX-10R
Zx 10r Here are the steps to remove and replace the front wheel of the Kawasaki ZX-10R motorcycle, following the instructions below. First, place the motorc…
How to Change the Engine Oil in the Kawasaki ZX-10R?
How to Change the Engine Oil in the Kawasaki ZX-10R?
Zx 10r In this tutorial, we will see how to change the engine oil in the Kawasaki ZX-10R, a very simple and quick operation. First, ensure that the engine i…
How to Replace the Headlight Bulb on the Kawasaki ZX-10R
How to Replace the Headlight Bulb on the Kawasaki ZX-10R
Zx 10r In this video tutorial, follow the instructions to remove and replace the headlight bulb on the Kawasaki ZX-10R by following these simple steps. Firs…

How to Turn Off the "V-Belt" Warning Light on a Yamaha X-MAX 400 Scooter?

In this tutorial, learn how to turn off the "V-Belt" warning light on the Yamaha X-MAX scooter's instrument panel, a very simple and quick operation. Before doing this, ensure you have completed the required maintenance, specifically replacing the drive belt. Start by inserting the key and turning on the ignition, then open the small right glove compartment and unscrew the screw for the upper cover. Once removed, locate the white connector with a jumper attached, disconnect it, wait about 10 seconds, and reconnect it. If successful, the warning light will disappear.

Watch the video!


by ScegliAuto

More videos