Do it yourself
Frequently asked questions about cars and motorcycles
Replacing the rear brake pads on a Kymco Like 150i is straightforward. First, disconnect the brake cable and remove the two bolts securing the caliper to the disc. Once done, with the caliper completely free, you can extract the two worn pads. Insert the new pads you have purchased, which should be equivalent to the ones removed. If they do not fit (as they will obviously be thicker than the worn pads), you can slightly widen the seating by leveraging with a flat screwdriver. Refit the caliper and reconnect the cable. Good luck!

Updated on 11 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Like 150i To replace the front brake pads on a Kymco Like 150i, loosen the bolts securing the caliper to the brake disc. Once the bolts are loosened, you can s…
Like 150i Unscrew the two bolts that secure the brake caliper to the disc. At this point, remove the covers from the two small bolts related to the pads. You a…
Like 150i To replace the levers of the Kymco Like 150, you will need to loosen the screws that secure the front panel of the motorcycle and the corresponding w…

How to Service the Piaggio Vespa GTS 300

This brief guide will illustrate the main steps to perform the routine maintenance service on the Piaggio Vespa GTS 300, replacing the engine oil and oil filter. First, place the scooter on the centre stand and start by unscrewing the oil drain bolt found under the engine, allowing it to drain into a container for about ten minutes; then unscrew the oil filter cartridge using the appropriate tool, and hand-tighten the new one. Finally, unscrew the filler cap and top up, filling to the maximum level mark!

Watch the video!


by ScegliAuto

More videos