Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Disassembly and Replacement of Brake Levers on Kymco Xciting S 400i

Model: Kymco Xciting S 400i
Part:

This video is currently unavailable

In this video, we will see how to disassemble and replace the brake levers on a Kymco Xciting S 400i scooter in simple steps. First, remove any lever guards by unscrewing the pivot screw; then proceed to disassemble the lever itself by unscrewing the fixing screw with a flat screwdriver, as shown in the video.

At this point, install the new brake lever, securing it and then adjusting the lever travel to your liking. Finally, perform the same operation on the other lever, following the video until the end!


Updated on 11 April 2026 by ScegliAuto


Related tutorials

How to Replace the Levers on a Kymco Xciting VS 400i
How to Replace the Levers on a Kymco Xciting VS 400i
Xciting S 400i To replace the levers on a Kymco Xciting VS 400i, first loosen the nut that secures the lever pin to its housing on the side of the handlebars. Once …
Disassembly and replacement of the variator on the Kymco Xciting S 400i
Disassembly and replacement of the variator on the Kymco Xciting S 400i
Xciting S 400i This guide outlines the necessary steps for disassembling and replacing the variator on the Kymco Xciting S 400i scooter. First, place the scooter on…
How to Replace the Brake Lever on a Kymco Xciting S 400i?
How to Replace the Brake Lever on a Kymco Xciting S 400i?
Xciting S 400i To replace the brake lever on a Kymco Xciting S 400i, loosen the nut that secures the locking pin of the lever: this nut is located at its bottom. On…

How to Clean the Throttle Body on a Piaggio Beverly

In today's video, see how to clean the throttle body on a Piaggio Beverly. This operation applies to all models of the Beverly from 125 to 500 over various years. First, remember to work only with a cold engine to avoid unpleasant burns. Next, remove the seat by unscrewing the appropriate fastening clips. Once done, proceed to remove the scooter's body; find and remove the appropriate fastening clips. At this point, you can carry out the work in question and then reassemble everything as it was.

Watch the video!


by ScegliAuto

More videos