Do it yourself
Frequently asked questions about cars and motorcycles

Model: Kymco Xciting S 400i
Part:

To replace the brake lever on a Kymco Xciting S 400i, loosen the nut that secures the locking pin of the lever: this nut is located at its bottom. Once the nut is loosened and removed, unscrew the locking pin of the lever so that it can be pulled out from the top. Once the lever is freed, you can slide it out of its housing, allowing you to insert a new one. After installation, secure the lever and check that it functions correctly.

Updated on 19 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Xciting S 400i In this video, we will see how to disassemble and replace the brake levers on a Kymco Xciting S 400i scooter in simple steps. First, remove any lever…
Xciting S 400i In this guide, find instructions on how to remove and replace both the front and rear brake pads of the Kymco Xciting S 400i scooter. First, place yo…
Xciting S 400i To replace the rear brake pads on a Kymco Xciting S 400i, loosen the bolt that secures the brake caliper to the corresponding disc so that it can be …

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos