Do it yourself
Frequently asked questions about cars and motorcycles

Battery Replacement on Kymco Visa R

Model: Kymco Visar
Part: Battery

Video tutorial

As shown in the video, use a cross screwdriver to remove the two screws securing the right rear fairing, and then remove it. Disconnect the yellow box and the transparent tube now exposed to access the battery cover easily. Unscrew the two screws holding it in place and remove the cover.

At this point, you can extract the battery by pulling it sideways and disconnecting the two cables: remember to always disconnect the negative terminal first and then the positive. Reverse the steps for reassembly.


Updated on 16 April 2026 by ScegliAuto


Related tutorials

Visar To replace the battery on a Kymco Visa R 110, loosen the screws securing the right side panel of the motorcycle, located near the under-seat compartm…
Visar To replace the air filter on the Kymco Visa R, you need to loosen the securing bolts that hold the box containing the filter. This box is located bet…
Visar To change the engine oil of the Kymco Visa R, loosen the drain plug located at the bottom of the bike to collect the used oil in a suitably placed co…
ScegliAuto offers an extensive international collection of automotive tutorials available in 12 languages. Each guide combines instructional videos with original explanations written by experienced human editors, along with information about the car models covered.

How to replace the stator on the Sherco SEF 300?

To replace the stator on the Sherco SEF 300, loosen the screws securing the cover on the right side of the bike: once this is released from the screws, it can be completely removed to access the underlying stator. This can now be freed from its housing by unscrewing the screws that hold it and disconnecting the appropriate cables: this will allow you to insert the new one. This can now be properly connected and secured, covering everything with the cover to check its operation.

Watch the video!


by ScegliAuto

More videos