Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Today, we will explore the guide and main steps to carry out the routine maintenance service by changing the engine oil of the Kymco Super8 150 scooter. First, place your scooter on the central stand and start unscrewing the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then unscrew the filler cap to drain the oil more quickly, as shown in the video. At this point, top up with the new engine oil of the correct type, finally checking the level with the dipstick!

Updated on 3 July 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Belt on a Kymco Super8 150?
How to Replace the Belt on a Kymco Super8 150?
Super 8 150 To replace the belt on a Kymco Super8 150, loosen the screws securing the transmission cover located on the left side of the bike near the rear wheel…
Dismantling and Replacing the Front Cowl of the Kymco Super8 150
Dismantling and Replacing the Front Cowl of the Kymco Super8 150
Super 8 150 Follow these simple steps to dismantle and replace the front cowl of the Kymco Super 8 150 scooter. First, place the scooter on the centre stand and …
How to Change the Engine Oil on a Kymco Super 8
How to Change the Engine Oil on a Kymco Super 8
Super 8 150 Here are the step-by-step instructions to perform the routine maintenance service by changing the engine oil and oil filter on the Kymco Super 8 scoo…

How to Replace the Front Headlight on the BMW F800GS

In this tutorial, you will see how to replace the front headlight on the BMW F800GS, an extremely simple and quick operation. First, ensure the key is not inserted for safety, then locate the power connector at the back of the headlamp and disconnect it by pressing the clip. Next, unscrew the two side bolts using a Torx T40 key, grasp the headlight and pull it away from the support. At this point, you can insert the replacement, tighten the two bolts, and reconnect the power connector.

Watch the video!


by ScegliAuto

More videos