Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Headlamp Bulb on the Kymco Xciting 300

Model: Kymco Xciting 300
Part: Headlight bulb

Video tutorial

To replace the headlamp bulb on the Kymco Xciting 300, fully loosen the screws securing the front fairing of the scooter so that it can be completely detached from its housing. Once the front fairing is removed, you will have access to the interior, allowing you to completely pull out the bulb from the headlamp and disconnect the power cable.

Connect the new replacement bulb to the power cable, insert it into the optical unit, and check that everything works correctly.


Updated on 15 July 2026 by ScegliAuto


Related tutorials

How to replace the front headlight bulbs on the Kymco Xciting 300i
How to replace the front headlight bulbs on the Kymco Xciting 300i
Xciting 300 The instructions in this guide will illustrate the procedure for removing and replacing the front headlight bulbs on the Kymco Xciting 300i scooter. …
How to Replace the Exhaust on a Kymco Xciting 300?
How to Replace the Exhaust on a Kymco Xciting 300?
Xciting 300 To replace the exhaust on a Kymco Xciting 300, loosen the screws that secure it to the mounting near the rear wheel on the right side. Once the screw…
How do you replace the transmission of the Kymco Xciting 300?
How do you replace the transmission of the Kymco Xciting 300?
Xciting 300 The transmission of the Kymco Xciting 300 can be replaced by loosening the screws that secure the transmission housing, located on the left side of t…

How to Clean the Throttle Body on a Piaggio Beverly

In today's video, see how to clean the throttle body on a Piaggio Beverly. This operation applies to all models of the Beverly from 125 to 500 over various years. First, remember to work only with a cold engine to avoid unpleasant burns. Next, remove the seat by unscrewing the appropriate fastening clips. Once done, proceed to remove the scooter's body; find and remove the appropriate fastening clips. At this point, you can carry out the work in question and then reassemble everything as it was.

Watch the video!


by ScegliAuto

More videos