Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Exhaust of the Kymco Downtown 300i

Model: Kymco Downtown 300i
Part: Exhaust muffler

Video tutorial

To replace the exhaust of the Kymco Downtown 300i, loosen the screws that secure it to its mounts on the right side of the bike near the rear wheel: once the mounting screws are loosened, you can widen the ring that connects the exhaust to the remaining part of the exhaust pipe, completely detaching it. When the old exhaust is freed, insert the new one into its place, connecting it to the exhaust pipe via the corresponding ring and securing it to the respective side mounts.


Updated on 10 October 2026 by ScegliAuto


Related tutorials

How do you replace the exhaust pipe of the Kymco Downtown 300i?
How do you replace the exhaust pipe of the Kymco Downtown 300i?
Downtown 300i To replace the exhaust on the Kymco Downtown 300i, it will be necessary to loosen the screws that hold it to the appropriate supports, on the right s…
How to Replace the Water Pump on the Kymco Downtown 300i?
How to Replace the Water Pump on the Kymco Downtown 300i?
Downtown 300i To replace the water pump on the Kymco Downtown 300i, access the housing located on the right side of the bike, near the beginning of the exhaust. Op…
How to Reset the "Service" Light on a Kymco Downtown 300i?
How to Reset the "Service" Light on a Kymco Downtown 300i?
Downtown 300i First, sit on the seat of your Kymco Downtown 300i. Start by activating the instrument panel by turning the key in the ignition switch. Next, press a…

Replacing the Rear Brake Pads of the BMW G310 GS

Follow these brief instructions to remove and replace the rear brake pads (this also applies to the front ones) of the BMW G310 GS motorcycle. First, place the bike on a stand and start by removing the pin and the clip from the rear brake caliper; then remove the old brake pads as shown in the video. Next, clean the caliper of any residual dirt, install the new original brake pads, and secure the pin and clip to lock everything in place, following the video tutorial to the end!

Watch the video!


by ScegliAuto

More videos