Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. Slk
    4. : How to change Mercedes C 220 low beam bulb

Mercedes Slk - Video tutorial

Model: Mercedes Slk MK 2, R171 - Years 2004-2011
Part: Headlight bulb
Operation: How to change Mercedes C 220 low beam bulb

The replacement of the headlight bulb (H7 socket) on this model of car cannot be carried out by accessing from the engine compartment as there is not enough room for maneuver; you must therefore lift the car on the jack (preferably by applying a car stand), remove the front wheel and proceed with the removal of the wheel arch lining; at this point it is possible to remove the protective cap from behind the headlight, disconnect the bulb power socket and unhook the relative fixing spring to be able to extract it from its seat and install the new one by proceeding backwards.


Posted on 21 September 2023 by ScegliAuto



How to replace low beam bulbs on a Mercedes SLK
Mercedes Slk (1997-2004 / R170, MK 1) In this video tutorial we will see how to remove and how to replace the low beam bulbs in the headlights of a Mercedes SLK. First of all, you need to
Mercedes Slk fuse box diagram
Mercedes Slk (1997-2004 / R170, MK 1) On this car model of the German house there are two fuse boxes, the first is located in the passenger compartment on the left side of the dashboard,
Where are the fuses located in the Mercedes SLK?
Mercedes Slk (2011-2016 / R172, MK 3) The fuses of the Mercedes SLK are divided within the appropriate fuse boxes that are installed on the vehicle: in this car model, two boxes containin

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos