Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Engine Oil and Oil Filter Replacement for MV Agusta Brutale 750

Model: Mvagusta Brutale 750
Part: Engine oil

Video tutorial

This guide describes how to replace the engine oil and oil filter on an MV Agusta 750. Obtain 3 litres of Motul 7100 SAE 10W40 oil and an HIFLO HF554 oil filter. Position the motorcycle on the side stand.

Start the engine, allow it to reach temperature, and then switch off. Place a container for used oil disposal under the engine. Use a ratchet and a 10 mm hex socket to remove the oil drain plug located at the bottom of the engine.

Allow the oil to drain and clean the plug thoroughly. Remove the two 4 mm Allen screws and detach the oil radiator duct.

Release the two side clips of the oil radiator by rotating them downwards. Use an oil filter wrench to remove the oil filter located at the bottom of the engine on the right side.

Place the oil recovery container under the oil filter. Lubricate the gasket of the new oil filter.

Screw it on by hand, then tighten it a turn with the oil filter wrench. Refit the radiator and duct, then reattach the oil drain plug.

Open the oil filler cap located on the right side of the crankcase. Pour in 2.8 litres of oil. Start the engine for one minute and switch off. Check the level through the inspection hole.


Updated on 9 March 2026 by ScegliAuto


Related tutorials

How to Remove the Engine from the MV Agusta Brutale 750?
How to Remove the Engine from the MV Agusta Brutale 750?
Brutale 750 To remove the engine from the MV Agusta Brutale 750, loosen the screws that secure it to the corresponding mounts: these screws will be located at th…
How to Remove the Thermostat on an MV Agusta Brutale 750
How to Remove the Thermostat on an MV Agusta Brutale 750
Brutale 750 In this tutorial, you will learn how to remove and replace the coolant thermostat on the MV Agusta Brutale 750, as well as the Brutale 910. First, pl…
How to replace the clutch cylinder on the MV Agusta Brutale 750?
How to replace the clutch cylinder on the MV Agusta Brutale 750?
Brutale 750 To replace the clutch cylinder on the MV Agusta Brutale 750, loosen the screws that secure the cylinder to its housing on the right side of the bike.…

How to Change the Engine Oil in a Yamaha XMAX 250 Scooter

In this tutorial, you will see how to change the engine oil in a Yamaha XMAX 250 scooter, a very simple and quick operation to perform every 12 months. First, ensure the engine is cool enough, then place a container underneath it. Locate the drain bolt on the left side and, using a socket wrench, unscrew it completely. Allow all the oil in the system to drain out, then open the filter housing and proceed with its replacement. At this point, reassemble everything and pour in the new oil through the designated hole.

Watch the video!


by ScegliAuto

More videos