Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Cleaning the Brake Caliper on Mvagusta F3

Model: Mvagusta F3 675
Part: Checks and maintenance

Video tutorial

Position the motorcycle on the rear stand and cut the sensor wire ties with wire cutters, then remove it from the mudguard. Using a torque wrench, remove the caliper without scratching the wheel: first, unscrew the lower bolt and then the upper one. Without fully removing it, tilt the caliper to create space between the pads.

These should be removed while remembering their position. Remove the retaining spring.

Open the brake fluid reservoir and slightly extend the brake cylinders. To clean the caliper, remove dirt using a degreaser, a brush, and a toothbrush.


Updated on 16 April 2026 by ScegliAuto


Related tutorials

How to Adjust the Chain on the MV Agusta F3 675
How to Adjust the Chain on the MV Agusta F3 675
F3 675 This guide will show you how to adjust the drive chain on the MV Agusta F3 675 motorcycle, as well as the F3 800. First, place the motorcycle on a st…
How do you replace the battery of the MV Agusta F3 675?
How do you replace the battery of the MV Agusta F3 675?
F3 675 In order to replace the battery of the MV Agusta F3 675, you will need to loosen the screws that secure the panel located on the left side of the bik…
How to Change the Time on the Dashboard of the MV Agusta F3 675
How to Change the Time on the Dashboard of the MV Agusta F3 675
F3 675 This guide will help you adjust the time on the display of the dashboard of the MV Agusta F3 675. First, turn on the dashboard by turning the key to …

How to Change the Engine Oil in a Yamaha XMAX 250 Scooter

In this tutorial, you will see how to change the engine oil in a Yamaha XMAX 250 scooter, a very simple and quick operation to perform every 12 months. First, ensure the engine is cool enough, then place a container underneath it. Locate the drain bolt on the left side and, using a socket wrench, unscrew it completely. Allow all the oil in the system to drain out, then open the filter housing and proceed with its replacement. At this point, reassemble everything and pour in the new oil through the designated hole.

Watch the video!


by ScegliAuto

More videos