Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Exhaust Gas Sensor on Mv Agusta F3 675 - 800

Model: Mvagusta F3 675
Part: Door lock

Video tutorial

In today's tutorial, you will learn how to remove the exhaust gas sensor on the Mv Agusta F3 675, as well as the 800, by following the instructions below. First, remove the lower and side fairings of your bike; to do this, unscrew all the fastening screws with a hex key. Next, remove the ECU and the sensor wiring, then disconnect the cables leading to the exhaust.

Now remove the entire assembly that connects to the exhaust manifold, as illustrated in the video. For reassembly, simply apply the reverse procedure!


Updated on 26 April 2026 by ScegliAuto


Related tutorials

How to Replace the Battery on the MV Agusta F3 675 - 800
How to Replace the Battery on the MV Agusta F3 675 - 800
F3 675 .. battery on the MV Agusta F3 675, as well as the 800. First, remove the two plastic covers located on the side of the fuel tank; then take off the rear.. …
How to Adjust the Chain on the MV Agusta F3 675
How to Adjust the Chain on the MV Agusta F3 675
F3 675 .. MV Agusta F3 675 motorcycle, as well as the F3 800. First, place the motorcycle on a stand and locate the two chain adjustment screws on the rear swingarm;.. …
How to remove and replace the fairings on the MV Agusta F3 675
How to remove and replace the fairings on the MV Agusta F3 675
F3 675 .. fairings of the MV Agusta F3 675, as well as the 800 model. First, place your bike on a stand and begin unscrewing all the side screws found on the upper.. …

How to Change the Engine Oil in a Yamaha XMAX 250 Scooter

In this tutorial, you will see how to change the engine oil in a Yamaha XMAX 250 scooter, a very simple and quick operation to perform every 12 months. First, ensure the engine is cool enough, then place a container underneath it. Locate the drain bolt on the left side and, using a socket wrench, unscrew it completely. Allow all the oil in the system to drain out, then open the filter housing and proceed with its replacement. At this point, reassemble everything and pour in the new oil through the designated hole.

Watch the video!


by ScegliAuto

More videos