Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In today's video tutorial, we will see how to remove and replace the clutch cover on the MV Agusta F3 675 and 900, as well as the F4 1000. First, unscrew all the fastening screws found on the sides of the clutch cover using an Allen key; then remove the old gasket and clean the base of the cover thoroughly. At this point, if necessary, replace the clutch by unscrewing all the central screws; finally, reassemble the new gasket and the cover, following the video to the end!

Updated on 2 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Brake and Clutch Levers on MV Agusta F3
How to Replace the Brake and Clutch Levers on MV Agusta F3
F3 800 In this video tutorial, learn how to remove and replace the brake and clutch levers on an MV Agusta F3 in simple steps. First, remove the clutch leve…
How do you replace the clutch of the MV Agusta F3 800?
How do you replace the clutch of the MV Agusta F3 800?
F3 800 To replace the clutch of the MV Agusta F3 800, you need to loosen the screws that secure the casing located on the right side of the motorcycle: once…
How do you replace the clutch of the MV Agusta F3 800?
How do you replace the clutch of the MV Agusta F3 800?
F3 800 To replace the clutch on the MV Agusta F3 800, you will need to loosen the screws that secure the casing located on the inner side of the right side …

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos