Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing Rear Bulbs on Renault Clio 2

Model: Renault Clio Clio 2, MK 2 - Years 1998-2005
Part: Tail light bulb

The lowest and side bulb is for the position light, the one at the bottom towards the boot is for the fog light, the centre-lower light is for reverse, and the centre-upper is for the indicator. Finally, the highest bulb is for the stop light. Open the boot door and unscrew the screw located in the frame, at the back of the affected light. Pull the light unit out of its housing and disconnect the connector. By slightly opening the fixing levers, as shown in the video, you can detach the cover where all the bulbs are fixed. Unscrew the bulb to be replaced and screw in the new bulb.

Updated on 2 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Removing the Rear Light and Replacing Bulbs on Renault Clio 3
Removing the Rear Light and Replacing Bulbs on Renault Clio 3
Renault Clio (2005-2013 / MK 3, Clio 3, Clio III) This guide shows how to remove the rear light and replace the bulbs on the third series Renault Clio, following these simple steps. First, open the t…
How to Replace the Rear Headlamp Bulbs on the Renault Clio 4
How to Replace the Rear Headlamp Bulbs on the Renault Clio 4
Renault Clio (2012-2019 / Clio IV, MK 4, Clio 4) In this video, learn how to remove and replace the rear headlamp bulbs on the fourth series Renault Clio by following these simple steps. First, open…
Replacing the Rear Light Bulbs on a Renault Clio 4
Replacing the Rear Light Bulbs on a Renault Clio 4
Renault Clio (2012-2019 / Clio IV, MK 4, Clio 4) In this video, you will see step-by-step instructions to remove and replace all the rear light bulbs on a fourth-generation Renault Clio. First, open…

How to Bleed the Clutch on a Renault Clio?

To bleed the clutch on a Renault Clio, open the bonnet to access the components located in the engine bay: here, you will need to undo the screws that secure the battery in its housing, the intake manifold, and the coolant reservoir. This will allow you to locate the pipe through which the brake fluid flows: by inserting the other end of the pipe into a container, you can press the clutch pedal to expel all the fluid until it fills the container.

Watch the video!


by ScegliAuto

More videos