|
Do it yourself
| |||
| ||||
|
Model: Sherco Se R 250
To replace the water pump bearing on the Sherco SE 250 R, loosen the screws securing the cover containing the water pump, located on the right side of the bike, next to the clutch cover. Once the water pump is removed, use a screwdriver to pry it out by inserting it into the upper hole of the bearing. This will allow you to extract the bearing from its housing and replace it with a new spare part. After the replacement, reinstall all previously removed parts.
Updated on 27 April 2026 by ScegliAuto
Video tutorial
Related tutorials
Se R 250
To install the radiator guards on the Sherco SE 250, completely remove the fairings located on the front sides of the bike. Once these are removed, y…
Se R 250
To replace the piston of the Sherco SE 250, loosen the bolts securing the cylinder at the top of the engine block. You will also need to disconnect t…
Se R 250
In this short video, you will see how to remove the engine air filter on a Sherco SE-R 250 enduro bike in simple and quick steps. First, remove the r…
|
How to Replace the Battery in a Yamaha Vino 125 Scooter?
In this tutorial, you will see how to replace the battery in a Yamaha Vino 125 scooter, a very simple and quick operation. First, ensure that the key is not inserted for safety. Then, lift the rubber mat and, using a simple cross-head screwdriver, unscrew the two screws securing the plastic cover. Once opened, disconnect both terminals, starting with the negative, and remove the battery from its housing. To fit the replacement, simply follow the reverse procedure. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.006
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
