Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Sherco
    3. : Se R 250

Sherco Se R 250 - Video guides

Sherco Se R 250
How to Install Radiator Guards on the Sherco SE 250
To install the radiator guards on the Sherco SE 250, completely remove the fairings located on the front sides of the bike. Once these are removed, you will …Read all…
Posted on 6 September 2026 by ScegliAuto
Sherco Se R 250
How to Replace the Piston of the Sherco SE 250
To replace the piston of the Sherco SE 250, loosen the bolts securing the cylinder at the top of the engine block. You will also need to disconnect the …Read all…
Posted on 2 August 2026 by ScegliAuto
Sherco Se R 250
How to Replace the Piston of the Sherco SE 250?
To replace the piston of the Sherco SE 300, access the top of the engine to unscrew the bolts that secure the cylinder to its housing. Once the bolts and …Read all…
Posted on 16 July 2026 by ScegliAuto
Sherco Se R 250
How to Remove the Air Filter on Sherco SE 250
In this short video, you will see how to remove the engine air filter on a Sherco SE-R 250 enduro bike in simple and quick steps. First, remove the rider's …Read all…
Posted on 21 June 2026 by ScegliAuto
Sherco Se R 250
How to Replace the Water Pump Bearing on a Sherco SE 250 R?
To replace the water pump bearing on the Sherco SE 250 R, loosen the screws securing the cover containing the water pump, located on the right side of the …Read all…
Posted on 11 June 2026 by ScegliAuto
Sherco Se R 250
Fitting the Clutch on Sherco SE 250-300
In this video tutorial, learn how to replace the clutch on a Sherco SE 250 and 300 by following these simple instructions. First, remove the old discs by …Read all…
Posted on 6 May 2026 by ScegliAuto
Sherco Se R 250
Post-Winter Maintenance for Sherco SE-R 250
Here is a simple tutorial to get your Sherco running again after the winter break. Check the spark plug and clean it using fine-grit sandpaper. Use a feeler …Read all…
Posted on 3 May 2026 by ScegliAuto

How to Connect the Cables to the Battery of the Citroen Xsara Picasso?

In this tutorial, you will see how to connect the cables to the battery of the Citroen Xsara Picasso, useful if you need to recharge it or perform an emergency start. First, ensure the key is not inserted, then open the bonnet and move to the front of the left headlamp. Next, locate the bolt just behind the filter box and connect the positive terminal clamp to it. Now you can connect the negative terminal to any point on the chassis, such as the indicated point. Once the operation is complete, ensure you disconnect the negative first and then the positive.

Watch the video!


by ScegliAuto

More videos