Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Disassembly of the gear knob on the Smart Fortwo 450

Model: Smart Smart 450 - Years 1998-2007
Part: Shift knob

In this short video we will see how to remove and replace, in simple steps, the gear knob on the Smart Fortwo 450, first generation, but also on the 451 and Forfour. First of all we get on board the car to start removing the knob; to do this, simply pull it upwards with force, in order to release it from the clips that we find below, as shown in the video. At this point we are going to check the state of the plastic supports; then we reassemble the new knob, inserting it perfectly up to the interlocking (the important thing is not to create any play between the knob and the lever).

Posted on 13 September 2021 by ScegliAuto

Video tutorial

Related tutorials

Disassembly of the gear knob of the Smart Fortwo 450
Disassembly of the gear knob of the Smart Fortwo 450
Smart (1998-2007 / 450) Let's see in this video how to remove and replace the original gear knob of the Smart Fortwo 450, but also of the 451 and the Roadster, following the…
Replacement of the gear knob of the Smart Fortwo 450
Replacement of the gear knob of the Smart Fortwo 450
Smart (1998-2007 / 450) In today's video we will see how to disassemble and replace the automatic gear knob of the Smart Fortwo 450 first series, but also of the 451 and the…
How to replace the gear knob on a Smart ForTwo
How to replace the gear knob on a Smart ForTwo
Smart (1998-2007 / 450) Before we can begin, we will have to go and sit in the driver's seat of our Smart ForTwo. To carry out this operation in total safety, it is highly r…

How to Disassemble and Remove the Rear Camera of a Mercedes CLA

In this video, see how to disassemble and remove the camera (where the license plate light is located) from the rear hatch of a Mercedes CLA. First, open the rear hatch of the car, then remove the rear license plate. Use a screwdriver to remove the screws on the plastic trim of the hatch. Disconnect the plastic trim of the license plate light from the hatch, and use a screwdriver to remove the retaining clips (located between the hatch metal and the plastic trim). Finally, remove the rear camera located in the hatch (disconnect the power connector of the camera) of the car. For reassembly, proceed in reverse order.

Watch the video!


by ScegliAuto

More videos