Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the fan motor of the Smart 451

Model: Smart Smart 451 - Years 2007-2015

In this video we will show you how to replace the Smart 451 fan motor. Remove the old fan motor and make sure the new one is of the same model. Insert the cap into its housing as seen in the video and fix it with its screws. Tighten the screws firmly using a socket wrench. Once this is done, apply the metal support that will serve to secure the entire block in the engine compartment. Insert the fitting from which the cannula that will transport the air to the system will start, unscrewing it from the piece you have just disassembled. Now that you have assembled the piece, proceed to install it in its housing inside the engine compartment.

Posted on 6 May 2022 by ScegliAuto

Video tutorial

Related tutorials

How to install the clutch actuator on the Smart Fortwo 451
How to install the clutch actuator on the Smart Fortwo 451
Smart (2007-2015 / 451) In today's video tutorial we will see how to install the clutch actuator on the Smart Fortwo 451, following the instructions below. First of all we l…
How to obtain the repair manual for the Smart 451 convertible top.
How to obtain the repair manual for the Smart 451 convertible top.
Smart (2007-2015 / 451) Usually when you buy a car, you are also given the maintenance and repair booklet, but in this case you need the repair manual for the Smart 451 conv…
To reset the service indicator of the Smart 451.
Smart (2007-2015 / 451) If even after performing the regular maintenance of your Smart 451 (year 2007-2015) you notice that the alarm light continues to turn on on the dashb…

    Frequently Asked Questions

    • Smart 1998-2007 - Where is the lateral acceleration sensor located in a Smart 450? Read answer

Removing the Timing Belt on a Suzuki Vitara

In this video, see the removal and replacement of the timing belt and water pump on a Suzuki Vitara. Open the bonnet and lift it, securing it in place. Use a socket wrench to remove the cooling radiator along with the associated hoses. Disconnect the power wiring using pliers, and remove the plastic undertray with a screwdriver. Use a spanner to loosen the tensioner pulley and slide the belt off its seat. Use a socket wrench to unscrew the tensioner pulley bolt, and remove the water pump as shown in the video. Fit the new water pump, the tensioner, and the belt itself, tightening everything with the socket wrench. Finally, reinstall the radiator with the securing bolts.

Watch the video!


by ScegliAuto

More videos