Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to open the remote control of the Toyota Yaris?

Model: Toyota Yaris Xp130 - Years: 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019
Part: Key

See other generations:
Video tutorial

In this tutorial, you will see how to open the remote control of the Toyota Yaris, a very simple and quick operation, for example, if you need to replace the battery. You will only need a small flat-head screwdriver and a replacement battery of type CR2016. First, locate the slot on the lower edge of the remote control, near the ring, then insert the screwdriver into it, lever it open, and remove the rear cover.

At this point, extract the battery, insert the replacement, and reassemble everything.


Updated on 6 November 2026 by ScegliAuto


Related tutorials

Replace the battery of the Toyota Yaris remote control.
Replace the battery of the Toyota Yaris remote control.
Toyota Yaris (2005-2011 / Xp90) The author of this video shows us how to replace the battery of a 2007 Toyota Yaris remote control, but the same tutorial is also valid for later mod…
How to replace the battery of the Toyota Yaris remote control?
How to replace the battery of the Toyota Yaris remote control?
Toyota Yaris (2005-2011 / Xp90) Replacing the battery of the Toyota Yaris remote control, as we can see in this tutorial, is an extremely simple and quick operation. To do this, we …
How to program the remote control key of the Toyota Yaris
How to program the remote control key of the Toyota Yaris
Toyota Yaris (2005-2011 / Xp90) These short and simple steps will show us how to program the remote control key of the Toyota Yaris. First of all, we get into the car with the remot…

How to reset the Service light on a 2019 Jeep Renegade?

The Service light, depicted as a yellow spanner, illuminates as scheduled to remind the driver that it is time for scheduled maintenance. This means that the set mileage has been reached, or the expected time has passed. The procedure involves turning on the instrument cluster, pressing the accelerator three times, and then turning off the ignition. After this, keep the brake pressed, turn the ignition back on, and then turn it off again. Upon the next ignition, you will notice that the light has been reset.

Watch the video!


by ScegliAuto

More videos