Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Rear Windscreen Wiper Motor Fuse on a Volkswagen Up

Model: Volkswagen Up MK 1 - Years: 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022
Part: Fuse box

Video tutorial

In this brief guide, you will find instructions to replace the rear windscreen wiper motor fuse on a Volkswagen Up. First, get inside the cabin and remove the plastic cover located at the bottom on the driver's side, beneath the light switch. Then, use the appropriate pliers to remove the 15 A fuse found at the top right (blue in colour), as shown in the video.

At this point, replace and install the new fuse of the correct type and with the same amperage; all that’s left is to check the operation of the rear windscreen wiper!


Posted on 23 March 2026 by ScegliAuto


Related tutorials

Where are the Fuses in the Volkswagen Up?
Where are the Fuses in the Volkswagen Up?
Volkswagen Up (2011-2024 / MK 1) In the Volkswagen Up, there are two fuse boxes: one in the engine compartment located above the battery, unclip the cover tabs and remove it; the oth…
Fuses Box Location on Volkswagen Up!
Fuses Box Location on Volkswagen Up!
Volkswagen Up (2011-2024 / MK 1) In this video tutorial, you will see the location of the fuses box on the Volkswagen Up. The fuses box is located inside the vehicle, on the left sid…
What is the Fuse Diagram for the Volkswagen Up?
Volkswagen Up (2011-2024 / MK 1) In this video, you can see the location of the fuse boxes and their corresponding diagrams in the Volkswagen Up, useful in case you need to check the…

How to reset the Service light on a 2019 Jeep Renegade?

The Service light, depicted as a yellow spanner, illuminates as scheduled to remind the driver that it is time for scheduled maintenance. This means that the set mileage has been reached, or the expected time has passed. The procedure involves turning on the instrument cluster, pressing the accelerator three times, and then turning off the ignition. After this, keep the brake pressed, turn the ignition back on, and then turn it off again. Upon the next ignition, you will notice that the light has been reset.

Watch the video!


by ScegliAuto

More videos