Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Yamaha Yzf R125
Part:

To replace the grips on the Yamaha YZF R125, remove the bar ends using an Allen key while holding the grips steady. At this point, carefully cut off the old grips with a utility knife to extract them; take great care when performing this operation. To fit the new grips, it is advisable to lubricate the inside with some alcohol: once inserted, make a hole to fit the bar ends. After making the hole, you can insert the bar ends and re-tighten them: at the end, it is advisable to finish tightening using an Allen key.

Updated on 19 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to replace the battery of the Yamaha YZF R125
How to replace the battery of the Yamaha YZF R125
Yzf R125 Today's steps will show us how to disassemble and replace the battery of the Yamaha YZF R125 motorcycle, following the instructions below. First, we …
How do you replace the brake pads of the Yamaha YZF R125?
How do you replace the brake pads of the Yamaha YZF R125?
Yzf R125 In order to replace the brake pads of the Yamaha YZF R125, the same operation must be carried out for both the front wheel and the rear wheel: once t…
How to replace the engine oil in the Yamaha YZF R125?
How to replace the engine oil in the Yamaha YZF R125?
Yzf R125 In this tutorial, we can see how to replace the motor oil in the Yamaha YZF R125, an extremely simple and fast operation. First of all, make sure tha…

How to Turn Off the "V-Belt" Warning Light on a Yamaha X-MAX 400 Scooter?

In this tutorial, learn how to turn off the "V-Belt" warning light on the Yamaha X-MAX scooter's instrument panel, a very simple and quick operation. Before doing this, ensure you have completed the required maintenance, specifically replacing the drive belt. Start by inserting the key and turning on the ignition, then open the small right glove compartment and unscrew the screw for the upper cover. Once removed, locate the white connector with a jumper attached, disconnect it, wait about 10 seconds, and reconnect it. If successful, the warning light will disappear.

Watch the video!


by ScegliAuto

More videos