Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In this tutorial, you will see how to remove the engine warning light on the Yamaha YZF-R125, a very simple operation. Before doing this, ensure you have resolved the issue causing the light to turn on and have obtained the scanner shown in the video. Start by removing the rider’s seat to access the battery compartment, then locate the OBD socket and connect the scanner. Once connected, start the error scan, select "ERASE CODES" and wait for the procedure to complete. Finally, restart the ignition and check that the operation was successful.

Updated on 17 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How do you replace the brake pads of the Yamaha YZF R125?
How do you replace the brake pads of the Yamaha YZF R125?
Yzf R125 .. to replace the brake pads of the Yamaha YZF R125, the same operation must be carried out for both the front wheel and the rear wheel: once the screws.. …
How to replace the battery of the Yamaha YZF R125
How to replace the battery of the Yamaha YZF R125
Yzf R125 .. and replace the battery of the Yamaha YZF R125 motorcycle, following the instructions below. First, we put the motorcycle on the stand and start.. …
How to replace the engine oil in the Yamaha YZF R125?
How to replace the engine oil in the Yamaha YZF R125?
Yzf R125 .. how to replace the motor oil in the Yamaha YZF R125, an extremely simple and fast operation. First of all, make sure that the engine is cool enough,.. …

How to Service the Piaggio Vespa GTS 300

This brief guide will illustrate the main steps to perform the routine maintenance service on the Piaggio Vespa GTS 300, replacing the engine oil and oil filter. First, place the scooter on the centre stand and start by unscrewing the oil drain bolt found under the engine, allowing it to drain into a container for about ten minutes; then unscrew the oil filter cartridge using the appropriate tool, and hand-tighten the new one. Finally, unscrew the filler cap and top up, filling to the maximum level mark!

Watch the video!


by ScegliAuto

More videos