Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Yamaha Mt 07
Part: Engine oil

To change the motor oil of a Yamaha MT-07, start by safely lifting the motorcycle using a stand to ensure stability. Under the engine, locate the oil drain plug, usually located on the bottom of the engine case. Place a container under the plug to collect the old oil. Use a wrench to loosen and remove the drain plug, allowing the oil to completely drain into the container. After fully draining the oil, replace the drain plug and tighten it carefully to avoid leaks. Next, open the oil fill cap, typically located on the top of the engine, and slowly pour in the new oil. Make sure to use the type of oil recommended in the owner's manual. After adding the oil, replace the fill cap and check for any leaks around the drain plug and fill cap area. Finally, start the engine for a few minutes to allow the oil to circulate, then turn it off and check the level again to ensure it is correct.

Posted on 14 August 2024 by ScegliAuto

Video tutorial

Related tutorials

How to Change Engine Oil and Oil Filter on a Yamaha MT-07
How to Change Engine Oil and Oil Filter on a Yamaha MT-07
Mt 07 Let's go through the steps to change the engine oil and oil filter on the Yamaha MT-07, following the instructions below. First, unscrew and remove t…
How to change the motor oil of a Yamaha MT-07?
How to change the motor oil of a Yamaha MT-07?
Mt 07 To change the motor oil of a Yamaha MT-07, start by warming up the engine for a few minutes to make the oil more fluid and easier to drain. Turn off …
How to change the engine oil of a Yamaha MT-07?
Mt 07 To change the oil of the Yamaha MT-07, start by placing the motorcycle on a central stand or on a stable support. Before proceeding, start the engine…

How to replace the air filter in the Herald Classic 125?

In this tutorial, you will see how to replace the air filter in the Herald Classic 125, a very simple and quick operation. First, position yourself on the left side of the motorcycle, then grab the panel located under the seat, pull it towards you, and detach it from the frame. Next, unscrew the three fastening screws of the airbox cover, remove it, and take out the old filter from its housing. At this point, remove any dirt residue present, insert the replacement filter, and reassemble everything by following the reverse procedure.

Watch the video!


by ScegliAuto

More videos