Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. 206
    4. : Alternator

Peugeot 206 - Alternator

Peugeot 206 (1998-2012 / MK 1)
How to disassemble the alternator in the Peugeot 206?
In this tutorial, we can see how to disassemble the alternator in the Peugeot 206, a simple operation but one that requires good manual dexterity. First, we …read all…
Posted on 23 November 2023 by ScegliAuto
Peugeot 206 (1998-2012 / MK 1)
How do you replace the alternator of a Peugeot 206?
To replace the alternator of the Peugeot 206, you will need to open the hood and access the engine compartment. Once the plastic cover of the engine block has …read all…
Posted on 21 May 2023 by ScegliAuto
Peugeot 206 (1998-2012 / MK 1)
Peugeot 206 alternator disassembly instructions
In this video tutorial we will see how to remove the alternator of a Peugeot 206. First we open and lift the bonnet of our car: then we go to unscrew the upper …read all…
Posted on 8 February 2024 by ScegliAuto
Peugeot 206 (1998-2012 / MK 1)
Replace alternator on Peugeot 206
Replacing the damaged alternator on a Peugeot 206, let's see how to remove it from inside the engine compartment. We open the front hood where the engine is. …read all…
Posted on 2 December 2023 by ScegliAuto
Peugeot 206 (1998-2012 / MK 1)
How to replace the alternator of the Peugeot 206
As a first operation, unhook the hood from the special lever and lift it, now you will have to remove the protection on the side of the exhaust pipes, now …read all…
Posted on 27 September 2023 by ScegliAuto
Peugeot 206 (1998-2012 / MK 1)
Repair of the alternator with replacement of the belt
Disconnect the negative pole of the battery and move the cable away. Raise the car on the bridge, open the bonnet and unscrew the screws holding the bumper. …read all…
Posted on 19 July 2023 by ScegliAuto
Cigarette Lighter (2) Airbags (6) Alternator (6) Loudspeaker (3) Shock absorbers (3) Antenna (2) Air conditioning (1) Car stereo (11) Anti roll bar (1) Roof Rack Bars (1) Battery (9) Coil (3) Air Vents (4) Bushings (1) Arm (2) Gearbox (6) Spark plugs (7) Glow plugs (2) Soft top (4) Carburetor (1) Bodywork (1) Control unit (4) Key (16) Locking the trunk (1) Timing belt (17) V-belt (4) Air conditioning (1) Air conditioning controls (2) -board computer (10) Checks and maintenance (56) Dashboard (2) Bearing (2) Brake discs (2) Side indicator light (1) Headlight (15) Tail light (5) Fog lights (4) Air filter (11) Cabin air filter (7) Petrol filter (5) Diesel filter (9) Oil filter (7) Hand brake (2) Clutch (5) Injectors (6) Reverse gear switch (1) Accessory Kit (1) Light bulb (7) Side turn signal light bulb (1) Headlight bulb (18) Rear light bulb (8) Interior lights ceiling light bulb (3) Antifreeze liquid (1) Dashboard light (14) License plate light (3) Third brake light (1) Handle (1) Muffler (1) Mask (1) Engine (1) Window motor (1) Starter motor (8) Gear oil (3) Engine oil (8) Door panel (23) Front bumper (4) Rear bumper (2) Brake pads (4) Tires (2) Gear Shift Knob (11) Pump (7) Fuel pump (13) Door (2) Push button (1) Window lift button (3) Instrument cluster (15) Radiator (5) Passenger compartment heating radiator (6) Wheel (4) Fuse box (35) Seat (9) Drive shaft (1) Crankshaft RPM sensor (1) Coolant temperature sensor (3) Lock (1) Lambda sensor (1) Suspensions (3) Outside rearview mirror (13) Interior rearview mirror (2) Windscreen wipers (1) Thermostat (2) Engine head (4) Steering rods (1) Central tunnel (1) Valve (1) EGR valve (1) Interior blower (5) Steering wheel (5)

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos