Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. 206
    4. : Control unit

Peugeot 206 - Control unit

Peugeot 206 (1998-2012 / MK 1)
How to reset the BSI on a Peugeot 206.
In this video we see how to reset the BSI on a Peugeot 206: BSI is an acronym for Built-in System Interface and is a system introduced by the PSA group in …read all…
Posted on 19 March 2024 by ScegliAuto
Peugeot 206 (1998-2012 / MK 1)
How to reset the Peugeot 206 BSI ECU
In this guide, we will see how to reset the Peugeot 206 BSI control unit, following the instructions below. First of all, we open the bonnet of our car and …read all…
Posted on 28 December 2022 by ScegliAuto
Peugeot 206 (1998-2012 / MK 1)
Where is the engine control unit located in the Peugeot 206?
In this video we can see where the ECU is located in the Peugeot 206 and how to proceed if we need to replace it. As shown, it is positioned inside the engine …read all…
Posted on 30 November 2022 by ScegliAuto
Peugeot 206 (1998-2012 / MK 1)
How to reset the ECU of a Peugeot 206
The video shows how it is possible to reset the ECU of a Peugeot 206 first production series. This procedure is very useful above all because it would reset …read all…
Posted on 12 September 2022 by ScegliAuto
Cigarette Lighter (2) Airbags (6) Alternator (6) Loudspeaker (3) Shock absorbers (3) Antenna (2) Air conditioning (1) Car stereo (11) Anti roll bar (1) Roof Rack Bars (1) Battery (9) Coil (3) Air Vents (4) Bushings (1) Arm (2) Gearbox (6) Spark plugs (7) Glow plugs (2) Soft top (4) Carburetor (1) Bodywork (1) Control unit (4) Key (16) Locking the trunk (1) Timing belt (17) V-belt (4) Air conditioning (1) Air conditioning controls (2) -board computer (10) Checks and maintenance (56) Dashboard (2) Bearing (2) Brake discs (2) Side indicator light (1) Headlight (15) Tail light (5) Fog lights (4) Air filter (11) Cabin air filter (7) Petrol filter (5) Diesel filter (9) Oil filter (7) Hand brake (2) Clutch (5) Injectors (6) Reverse gear switch (1) Accessory Kit (1) Light bulb (7) Side turn signal light bulb (1) Headlight bulb (18) Rear light bulb (8) Interior lights ceiling light bulb (3) Antifreeze liquid (1) Dashboard light (14) License plate light (3) Third brake light (1) Handle (1) Muffler (1) Mask (1) Engine (1) Window motor (1) Starter motor (8) Gear oil (3) Engine oil (8) Door panel (23) Front bumper (4) Rear bumper (2) Brake pads (4) Tires (2) Gear Shift Knob (11) Pump (7) Fuel pump (13) Door (2) Push button (1) Window lift button (3) Instrument cluster (15) Radiator (5) Passenger compartment heating radiator (6) Wheel (4) Fuse box (35) Seat (9) Drive shaft (1) Crankshaft RPM sensor (1) Coolant temperature sensor (3) Lock (1) Lambda sensor (1) Suspensions (3) Outside rearview mirror (13) Interior rearview mirror (2) Windscreen wipers (1) Thermostat (2) Engine head (4) Steering rods (1) Central tunnel (1) Valve (1) EGR valve (1) Interior blower (5) Steering wheel (5)

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos