Do it yourself
| ||||
|
Searched for How To Reset Service Light On Gwm Steed 5 - To reset the service light on a GWM Steed 5, you can follow these steps:
1. Make sure the ignition is off.
Page generated automatically based on user searches (*)
How do you reset the Service light on the Greatwall Steed?
Great Wall Steed (2006-2023 / MK 1) .. To reset the Service light on the Greatwall Steed, you need to press and hold the button located on the..
How to mount the tarpaulin on the Great Wall Steed
Great Wall Steed (2006-2023 / MK 1) .. we see how to mount the cover on the Great Wall Steed. Using a tape measure, we take a fixed measurement of 10 cm all around, marking it with chalk,..
Remove the door panel of the Great Wall H6
Great Wall Steed (2006-2023 / MK 1) Remove the door panel of the Great Wall H6? We disassemble the front panel of the car following the guide. We remove the cover of the handle placed i
How to install the sliding cover on the rear tub of a Great Wall pick-up truck
Great Wall Great Wall H6 (2011-2016 / MK 1) .. rubber tubes, which we will exit from the rear lights. As shown in the video, we make the holes with the drill for the drainage points, two on the front..
How to perform a reset of the Great Wall H6
Great Wall Great Wall H6 (2011-2016 / MK 1) .. Performing a forced reset on a 2021 Great Wall H6 is a very simple operation that can be done independently, thanks also..
How much does a Great Wall Steed headlight fuse cost?
Answer: The headlight fuse on our Great Wall Steed costs approximately 50 cents, and can be purchased from any dealer, as well as online retail sites....
read all
Posted on 30-08-2021
After how many miles does the Greatwall Great Wall H6 timing belt need to be replaced?
Answer: The replacement of the Greatwall Great Wall H6 timing belt must be carried out in accordance with the instructions in the vehicle's use and maintenanc...
read all
Posted on 27-08-2022
|
Pagine correlate:
How to Reset the Service Light on a GWM Steed 5: To reset the service light on a GWM Steed 5, you can follow these steps:
1. Make sure the ignition is off.
2. Hold down the reset mileage button.
3. While holding the button, turn on the ignition.
4. Keep holding the button until the spanner lamp goes out.
5. Release the button.
Alternatively, you can use a scan tool to reset the service light. Simply connect the scan tool to the vehicle's OBD-II port and follow the instructions on the tool to reset the light.
If you are still experiencing issues with the service light, it is recommended to consult the vehicle's manual or seek assistance from a professional mechanic.
Information generated automatically based on external sources by AI systems and which may in some cases be inaccurate or incorrect. |
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.085
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |