Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Acura
    3. :
  3. Rdx
    4. : How to replace the Led license plate bulb of the Acura RDX

Acura Rdx - Video tutorial

Model: Acura Rdx MK 1 - Years 2006-2012
Part: License plate light
Operation: How to replace the Led license plate bulb of the Acura RDX

In this video we will see how to replace the Led license plate bulb of the Acura RDX. First of all unscrew the screws of the plate and remove it to have access to the two ceiling lights located on the upper part. Open the trunk of the car and remove, with a screwdriver or a thin piece of plastic, the panel located on the back in correspondence with the license plate. Disconnect the two manifolds inside the panel that power the two license plate bulbs. On the outside of the trunk, above the license plate, there is a plastic mask; gently remove it with a screwdriver or a thin piece of plastic. At this point, remove the two ceiling lights containing the old LED bulbs and replace them with the new ones. Once the terminals have been connected again, close everything by repeating the same operations in reverse.


Posted on 14 November 2022 by ScegliAuto

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos