Do it yourself
Frequently asked questions about cars and motorcycles
  1. Car
  2. :
  3. Alfa Romeo
  4. :
  5. 147
  6. : Removing the rear-view mirror on Alfa Romeo 147

Alfa Romeo 147 - Video tutorial

Model: Alfa Romeo 147 MK 1 - Years 2000-2010
Part: Outside rearview mirror
Operation: Removing the rear-view mirror on Alfa Romeo 147

Do we have the rearview mirror of our car damaged? Let's see how it disassembles. With a plastic lever, we go to pry between the perimeter of the mirror frame and the mirror glass of the same. We pry until the slide detaches from the mirror (we disconnect the power supply terminals); very delicate operation because the mirror could break. We assemble the new mirror, we are careful to hook the plastic snap clips into the mirror supports (we connect the power supply terminals to the mirror). Let's see if the mirror works electrically.


Posted on 30 November 2023 by ScegliAuto



How to remove the front bumper of an Alfa Romeo 147
Alfa Romeo 147 (2000-2010 / MK 1) Before starting, we will have to open the front hood of our Alfa Romeo 147. So let's start by unscrewing and removing all the screws and all the bolt
Where is the Alfa Romeo 147 fuse box located
Alfa Romeo 147 (2000-2010 / MK 1) If you cannot find the position in which the fuse box of your Alfa Romeo 147 is installed then all you have to do is pay attention to the following m
How to replace the clutch pump on the Alfa Romeo 147?
Alfa Romeo 147 (2000-2010 / MK 1) In order to replace the Alfa Romeo 147 clutch pump, you need to remove the panel located in the rear part of the pedals, under the steering column. O

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos