Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Performing a Rear Brake System Revision on the Aprilia RS 125

Model: Aprilia Rs 125

Video tutorial

In this video tutorial, you will learn how to carry out a revision of the brake system and replace the brake pump and pads on the Aprilia RS 125 motorcycle. First, remove the rear brake pump to replace the seals; then, bleed the brake fluid by connecting the pump to the rear caliper and opening the bleed screw.

Dismantle the caliper to replace the brake pads; the removal of the rear brake lever and button is also shown, disconnecting the electrical cable. Follow the video to the end!


Updated on 21 April 2026 by ScegliAuto


Related tutorials

How to Replace the Rear Wheel Bearing on an Aprilia RS 125
How to Replace the Rear Wheel Bearing on an Aprilia RS 125
Rs 125 Today's steps will show you the procedure for removing and replacing the rear wheel bearing on an Aprilia RS 125 motorcycle. First, place the motorcy…
Removing Water Pump on Aprilia RS 125
Removing Water Pump on Aprilia RS 125
Rs 125 In today's video, we will see how to remove the water pump and how to service it on an Aprilia RS 125 motorcycle, following these simple steps. First…
Replacing the Brake Fluid on Aprilia RS 125
Replacing the Brake Fluid on Aprilia RS 125
Rs 125 As usual, before performing any maintenance operations on a motorcycle (or a car), you must secure your motorcycle, in this case, the Aprilia RS 125,…

How to Reset the Oil Service Light on the Kymco DownTown 125i

This video shows how to reset the oil maintenance light on the Kymco DownTown 125i. This procedure is necessary after performing an oil change, and it is very simple and quick to carry out. To perform this procedure, start the instrument panel without starting the engine, then press the mode button until you reach the oil maintenance option, after which press the reset button for 5 seconds; the reset will then be successful, and you can restart the instrument panel to verify that the procedure has been completed correctly.

Watch the video!


by ScegliAuto

More videos