Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Rear Wheel Bearing on an Aprilia RS 125

Model: Aprilia Rs 125
Part: Bearing

Video tutorial

Today's steps will show you the procedure for removing and replacing the rear wheel bearing on an Aprilia RS 125 motorcycle. First, place the motorcycle on a stand to lift the rear wheel off the ground.

Then, unscrew the central axle to remove the wheel, disconnecting it from the drive chain. At this point, unscrew the fixing screws of the sprocket to remove it, then remove the wheel bearing using a puller.

Next, install the new bearing, ensuring it is perfectly seated, following the video tutorial until the end!


Updated on 9 October 2026 by ScegliAuto


Related tutorials

How to Replace the Drive Chain on the Aprilia RS 125
How to Replace the Drive Chain on the Aprilia RS 125
Rs 125 Following these brief and simple instructions, you will see how to disassemble and replace the drive chain on the Aprilia RS 125 motorcycle. First, p…
How to Replace the Clutch on the Aprilia RS 125
How to Replace the Clutch on the Aprilia RS 125
Rs 125 The procedure for replacing the clutch on the Aprilia RS 125 involves loosening the bolts that secure the clutch cover located on the right side of t…
How to Dismantle the Engine of an Aprilia RS 125?
How to Dismantle the Engine of an Aprilia RS 125?
Rs 125 To dismantle the engine of the Aprilia RS 125, loosen the bolts securing the engine block to its housing in the centre of the frame. Once the support…

How to Replace the Front Headlight Bulbs on a KTM Duke 125?

Replacing the front headlight bulb on the KTM Duke 125, as shown in this tutorial, is an extremely simple and quick task. First, ensure that the key is not inserted, then using a Torx screwdriver, remove both the bolts and the rivets securing the front fairing and separate it from the handlebars. Next, remove the large rubber cap located at the back of the headlight, disconnect the power connector, and unlock the metal clip. Once the bulb is extracted, insert the replacement without touching the glass directly with your bare hands, and finally reassemble everything.

Watch the video!


by ScegliAuto

More videos