Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to change the rear taillight of the Audi A3

Model: Audi A3 MK 3, 8V - Years 2012-2019
Part: Tail light

In these short and simple steps, we will see how to disassemble and replace the rear light of the Audi A3, following the instructions below. First, we open the rear hatch of the trunk and start removing the cover found on the side of the luggage compartment; then we unscrew the plastic screw and disconnect the electrical connector of the bulbs, as shown in the video. At this point, we gently remove the light from the outside, replacing the bulbs if necessary; we replace the entire light, following the video tutorial to the end!

Posted on 20 November 2024 by ScegliAuto

Video tutorial

Related tutorials

How to disassemble the rear headlight of an Audi A3?
How to disassemble the rear headlight of an Audi A3?
Audi A3 (2003-2013 / 8P, MK 2) To disassemble the rear light of an Audi A3, follow these steps. Start by opening the trunk door to access the light, then remove the internal side c…
How to remove the rear light of the Audi A3.
How to remove the rear light of the Audi A3.
Audi A3 (2012-2019 / MK 3, 8V) The steps to remove the rear light of an Audi A3 8V model vehicle are as follows: - open the trunk; - remove the side cover; - unscrew the two Torx s…
Removal of the rear light of the Audi A3
Removal of the rear light of the Audi A3
Audi A3 (2003-2013 / 8P, MK 2) Today we will see, in this short guide, the main steps that will allow us to disassemble and replace the rear light of the Audi A3. First of all we o…

How to Remove the Instrument Cluster on a Citroen Xsara Picasso

How to remove the instrument cluster located in the centre of the dashboard on a Citroen Xsara Picasso? Follow these steps to disassemble the parts: use a lever to remove the plastic covers of the instrument cluster. Unscrew the securing screws located at the sides of the instrument cluster with a screwdriver; after removing the screws, pull the piece out from the dashboard and disconnect the power cable located at the back of the instrument cluster. Fit the new piece or (replace the LEDs/bulbs in the cluster) and reassemble the same. Finally, reverse the assembly steps.

Watch the video!


by ScegliAuto

More videos