Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Rear Light of an Audi A3

Model: Audi A3 8V, MK 3 - Years 2012-2019
Part: Tail light

To remove the rear light of an Audi A3 model 8V, follow these steps: - open the boot; - remove the side cover; - unscrew the two Torx screws; - pull out the light; - disconnect the connector; - remove the light. Once the light is removed from its housing, you can replace the bulb. To do this, simply open the light unit, disconnect the internal connector, and pull out the blown bulb. Insert the new bulb and reconnect everything. After remounting the light in its housing, proceed to replace the bulb of the right rear light.

Updated on 9 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How to change the rear taillight of the Audi A3
How to change the rear taillight of the Audi A3
Audi A3 (2012-2019 / 8V, MK 3) In these short and simple steps, we will see how to disassemble and replace the rear light of the Audi A3, following the instructions below. First, w…
How to Remove the Rear Light on an Audi A3 S3 and RS3
How to Remove the Rear Light on an Audi A3 S3 and RS3
Audi A3 (2012-2019 / 8V, MK 3) This guide shows how to remove the rear light on an Audi A3, both in S3 and RS3 versions. The first operation is to open the boot and remove the trim…
How to disassemble the rear headlight of an Audi A3?
How to disassemble the rear headlight of an Audi A3?
Audi A3 (2003-2013 / MK 2, 8P) To disassemble the rear light of an Audi A3, follow these steps. Start by opening the trunk door to access the light, then remove the internal side c…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos