Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to start the Audi A3 when the remote control battery runs out?

Model: Audi A3 8V, MK 3 - Years 2012-2019
Part: Key

In this tutorial we can see how to start the Audi A3 in the event of a discharge of the remote control battery. First of all, let's go inside the passenger compartment using the metal key, then locate the small rectangular edge placed in the right area of the steering column and place the remote control on it. Once this is done, we will hear an acoustic signal and it will be possible to start the engine using the special "START" button. If the procedure does not work, let's repeat it and make sure to do everything within about 5 seconds, otherwise the connection between the key and the sensor will reset.

Posted on 3 October 2022 by ScegliAuto

Video tutorial

Related tutorials

How do you reset the low battery indicator on the Audi A3 key?
How do you reset the low battery indicator on the Audi A3 key?
Audi A3 (2012-2019 / 8V, MK 3) When the low battery symbol appears on the instrument panel of the Audi A3, it means that the key battery needs to be replaced. By replacing the batt…
How do you replace the battery of the Audi A3 key?
How do you replace the battery of the Audi A3 key?
Audi A3 (2012-2019 / 8V, MK 3) The inability to open the central locking of one's car is most often due to a flat remote control battery, except for some exceptions, such as cold s…
Replacing the remote control battery on the Audi A3 8P (MK2)
Replacing the remote control battery on the Audi A3 8P (MK2)
Audi A3 (2003-2013 / MK 2, 8P) Let's see in this short and simple guide how to remove and replace the key remote control battery on the second generation Audi A3 8P. First we take …

Other guides you may be interested in

How to Replace the Cabin Fan Resistor on a BMW 3 Series

How to Replace the Cabin Fan Resistor on a BMW 3 Series. Open the door and remove the plastic cover under the dashboard on the right side. Use a trim tool to pry off the cover next to the dashboard. Get a screwdriver or a cordless drill, open the glove compartment, and unscrew the fastening screws around the perimeter with a screwdriver. Once this is done, pull out the glove compartment and disconnect the power cables. Remove the fan resistor from its housing, insert the new part into the filter holder, and reassemble all the components of the glove compartment as you disassembled them earlier.

Watch the video!


by ScegliAuto

More videos