Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of the headlight bulb of the Benelli TNT 300

Model: Benelli Tnt 300
Part: Headlight bulb

Video tutorial

In a few steps we will see the instructions that will allow us to disassemble and replace the headlight bulb of the Benelli TNT 300. First of all, we put the motorcycle on the stand and start unscrewing the fixing screws of the front headlight; then disconnect the electrical connector to later remove the low beam or position bulb, as shown in the video.

At this point, we install the new low beam bulb, of the correct type and having the same attachment (in this case H7 type); we check the operation and finally reassemble the headlight assembly on the frame!


Posted on 25 October 2025 by ScegliAuto


Related tutorials

How do you replace the levers of the Benelli TnT 300?
How do you replace the levers of the Benelli TnT 300?
Tnt 300 In order to replace the levers of the Benelli TnT 300, you need to loosen the nuts that secure these levers to their housings: these will be located …
How to Replace the Air Filter on a Benelli TNT 300
How to Replace the Air Filter on a Benelli TNT 300
Tnt 300 In this video tutorial, you will learn how to disassemble and replace the air filter of the engine on a Benelli TNT 300 motorcycle, following the ins…
How to Replace the Battery of the Benelli TNT 300
How to Replace the Battery of the Benelli TNT 300
Tnt 300 In this video tutorial, you will learn how to remove and replace the battery of the Benelli TNT 300 motorcycle by following the instructions below. F…

How to Replace the Rear Brake Pads on a Benelli TRK 502X?

To replace the rear brake pads on a Benelli TRK 502X, loosen the screws that secure the corresponding caliper so that it can be detached from the brake disc: once the caliper is removed from its disc, you can proceed to detach it and remove the pin that secures the pads inside the caliper. At this point, you can remove the old pads from their seat to insert the new ones: these must be secured properly by positioning the caliper and checking that the brake is functioning.

Watch the video!


by ScegliAuto

More videos