Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Change the Engine Oil of a Beta 390RR-S?

Model: Beta 390 Rrs
Part: Engine oil

Video tutorial

To change the engine oil of a Beta 390RR-S, first warm up the engine for a few minutes to thin the oil. Then, switch off the engine and place the bike on a centre stand for stability. Locate the oil drain plug, which is found underneath the engine.

Position a collection tray under the plug and use a spanner to unscrew it, allowing the used oil to drain completely. Once the oil has fully drained, securely refit the drain plug.

Next, locate the oil filler cap, usually situated on one side of the engine. Remove the cap and slowly pour in the new oil using a funnel, following the manual's recommendations for the correct quantity.

After filling the oil, replace the filler cap and tighten it well. Start the engine for a few minutes and check for any oil leaks.

This ensures the engine has the correct amount of oil and operates properly.


Updated on 12 October 2026 by ScegliAuto


Related tutorials

How to Replace Oil and Oil Filter on a Beta 390Rrs
How to Replace Oil and Oil Filter on a Beta 390Rrs
390 Rrs How to replace oil and oil filter on a Beta 390Rrs? Follow this guide to proceed with the replacement. Position your bike on its original stand; usin…
How to Change the Engine Oil of the Beta 390 RS?
How to Change the Engine Oil of the Beta 390 RS?
390 Rrs You can change the engine oil of the Beta 390 RS by loosening the drain plug located at the central lower part of the vehicle: once this has been rem…
Oil Change on Beta 390 RRS
Oil Change on Beta 390 RRS
390 Rrs Start the engine for a few minutes to warm the oil, making it more liquid and easier to drain. As shown in the video, unscrew the three lower screws …

How to Polish the Exhaust of Malaguti Xsm 50

In this video, we will briefly go through the main steps to clean and polish the exhaust of the Malaguti Xsm 50 enduro bike. First, remove the silencer and exhaust manifold by unscrewing the fixing screws and nuts; then heat the exhaust to a high temperature to loosen any deposits inside. Next, proceed to polish the exhaust using a light metal brush and suitable products, following the video tutorial to the end!

Watch the video!


by ScegliAuto

More videos