Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Exterior Rearview Mirror on the Datsun Go

Model: Datsun Go MK 1 - Years: 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022
Part: Side mirror

Video tutorial

Today, you will see in this brief and simple guide the instructions on how to remove and replace the exterior rearview mirror on the Datsun Go. First, open the front door of your car and start removing the plastic cover located behind the mirror; then use a socket wrench with an extension to unscrew the mirror's screws, pulling it out from the outside, as shown in the video.

At this point, install the new mirror, securing it with its screws; finally, adjust the glass, following the video until the end!


Updated on 29 May 2026 by ScegliAuto


Related tutorials

How to Replace the Cabin Filter in the Datsun Go+
How to Replace the Cabin Filter in the Datsun Go+
Datsun Go (2013-2022 / MK 1) Replacing the cabin filter in the Datsun Go+ is a very simple and inexpensive task. First, sit in the passenger seat, then go under the dashboard and…
How to Replace the Cabin Air Filter in a Datsun Go
How to Replace the Cabin Air Filter in a Datsun Go
Datsun Go (2013-2022 / MK 1) Replacing the cabin air filter in your Datsun Go is a very important task that you can easily do on your own at any time. Here’s how to do it. First,…
Change the Engine Oil and Oil Filter on a Datsun Go
Change the Engine Oil and Oil Filter on a Datsun Go
Datsun Go (2013-2022 / MK 1) This short and simple video will show you the steps to perform the routine maintenance service by changing the engine oil and oil filter on the Datsu…

How to Replace the Glow Plugs in the Fiat Ducato 2.3 Multijet?

Glow plugs, as the name suggests, raise the temperature of the engine in diesel vehicles to allow for easier starting. The manufacturer, in this case, Fiat for the Ducato 2.3 Multijet, specifies how often they should be replaced, and a warning light will illuminate when it's time. This work is carried out under the bonnet. First, remove the upper engine cover, then lift the coil and, using a socket wrench of the appropriate size, unscrew the glow plug to remove it from the base, followed by installing the new one.

Watch the video!


by ScegliAuto

More videos