Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
It is recommended to start the engine for a few minutes before an oil change to warm up the circulating oil, making it less viscous and allowing it to drain more easily. Using a 14 mm spanner, unscrew the drain bolt clearly identified in the video and collect the used oil in a container (dispose of it properly). Once done, measure the amount of oil that has drained and tighten the drain hole. Refill the same amount of lubricant through the upper hole of the oil sump. You may take this opportunity to replace the engine oil filter if it is due while the lubricant is draining.

Updated on 20 April 2026 by ScegliAuto

This video is currently unavailable

Related tutorials

How do you replace the motor oil of the Ducati Panigale V4S?
How do you replace the motor oil of the Ducati Panigale V4S?
Panigale V4s The oil change of the Ducati Panigale V4S can be carried out by loosening the drain plug located in the central lower part of the vehicle: once this …
Engine Oil and Oil Filter Replacement for the Ducati Panigale V4s
Engine Oil and Oil Filter Replacement for the Ducati Panigale V4s
Panigale V4s The procedure for replacing the engine oil and oil filter is straightforward and does not require special tools; follow these steps to service the Du…
How to Replace the Air Filter on a Ducati Panigale V4S
How to Replace the Air Filter on a Ducati Panigale V4S
Panigale V4s To replace the air filter on a Ducati Panigale V4S, you need to loosen the screws that secure the cover. These screws are located at the front of the…

How to Dismantle the Engine of the GasGas EC 125?

The operation of dismantling the engine of the GasGas EC 125 is carried out by accessing the central part of the bike immediately under the seat. To remove it from its housing, unscrew the screws and disconnect the appropriate connectors. Once the engine has been extracted, you can separate the two half-cases that comprise it by unscrewing the fixing bolts. This will allow access to the clutch, which can be completely removed by sliding out all the discs; it will also be possible to detach the piston from the corresponding connecting rod after removing the cylinder.

Watch the video!


by ScegliAuto

More videos